OAR 918-500-0100: General Fees

The following fees apply to the division and do not apply to municipalities. Municipalities who have been delegated the manufactured dwelling alteration program by the division may establish their own fee schedule or adopt the division’s fee schedule through local ordinance. (1) Inspection Fee: $55 for an inspection requiring one hour or less, and $27.50 for every additional 30 minutes or fraction thereof exceeding one hour, including travel time. Mileage must be paid at the rate established by the Oregon Department of Administrative Services. (2) Field Technical Service Fee: $55 for service requiring one hour or less, and $27.50 for every additional 30 minutes or fraction thereof exceeding one hour, including travel time. Mileage must be paid at the rate established by the Oregon Department of Administrative Services. (3) Out-of-State Inspection or Field Technical Service Fee: In addition to the hourly charges of sections (1) and (2) of this rule, the division must be reimbursed for the actual cost based on published air fare or equivalent, plus required surface transportation and cost for food and lodging consistent with the allowances established by the Oregon Department of Administrative Services for authorized state employee travel. (4) Hourly Re-inspection Fee: Same fee schedule as noted in sections (1), (2), and (3) of this rule. (5) Change of Manufacturer’s Name, Ownership or Address Fee: $20 for each change. (6) Insignia Fee: $50 per insignia. (7) Replacement Insignia: $50 per insignia. (8) Alteration Permit Fees: (a) Alteration Inspection Fee: $125 per inspection including insignia of compliance; (b) Alternate Construction Inspection Fee: $55 per hour including travel time but not to exceed $300 for any one manufactured home; or (c) Single Visual Inspection Fee: $125 per inspection. (9) Installation Certification Tag: $8 per tag. (10) Manufacturer Registration Fee: $100 per facility. (11) Manufacturer Annual Registration Renewal Fee: $20 per facility. (12) Manufactured Dwelling Inplant Inspection Fee: $42.50 per floor inspected, and must be paid monthly. A maximum of four floor overlap inspections may be performed without charge during each regularly scheduled complete inplant inspection. The fee for re-inspections and additional overlap inspections may be charged at the rate for each floor or at the rate per hour, whichever is less. (13) Installer License Program Hitch Fee: $4 per floor produced in Oregon, and must be paid monthly. (14) Manufactured Dwelling Label or Tag Handling Fee: $2 per floor. (15) Plan Review Fee: $55 for non-structural plan review requiring one hour or less, and $27.50 for every additional 30 minutes or fraction thereof exceeding one hour. (16) Structural Plan Review Fee: $70 for plan review requiring one hour or less; $35 for every 30 minutes or fraction thereof exceeding one hour. (17) Manufactured Dwelling Installer License and Examination Fee: $55. (18) Education Provider Application Fee: $55. (19) Manufactured Dwelling Limited Installer and Limited Skirting Installer License Fee: $55. (20) Manufactured Dwelling Installer and Educational Provider Re-examination Fee: $40. (21) Manufactured Dwelling Temporary Limited Installer License Fee: $10. (22) Installer, Limited Installer and Limited Skirting Installer License Two-Year Renewal Fee: $80. (23) Manufactured Dwelling Accessory Building or Structure Installation Permit Fees: The fees are those published in the Oregon Residential Specialty Code. [Publications: Publications referenced are available from the agency.]